3D Printing Tip

By on March 19th, 2008 in blog

Tags:

An interesting forum post at 3DSociety.org talks about how best to reduce the “little sand-like jaggies on the surface” of your printed objects. Tim-Gibson writes:

Sometimes you can place your 3D model on the bed in a certain way so as to reduce the stepping on the flattest surface of you model. For instance if you were RPing a basic cube, a cube placed flat and parallel with the printing bed would be produced smoother than one you positioned at an angle with only one corner ‘touching’ the tray. make sense? kinda like you’re going with the grain of the wood. Check with your printer.

Too bad we often need to print more than basic cubes, but a great tip nevertheless.

Via CGSociety.org

By Kerry Stevenson

Kerry Stevenson, aka "General Fabb" has written over 8,000 stories on 3D printing at Fabbaloo since he launched the venture in 2007, with an intention to promote and grow the incredible technology of 3D printing across the world. So far, it seems to be working!

Leave a comment

Your email address will not be published. Required fields are marked *