If you’re 3D printing with plastic filament, you’ll be familiar with the layered effect, where progressive extrusions accumulate into an object. The object has the correct shape, but has unsightly ridges. What to do?
You can eliminate ridges with the Acetone technique, but it’s relatively dangerous, as acetone is flammable and generally not very nice. Another way to smooth your ABS prints is to use Stratasys’s FinishingTouch Smoothing Station. We got our hands on one and took a test drive.
The FinishingTouch uses an approach very similar to using acetone, but it’s much more optimized – and safer. The device has two chambers. Your ABS object is first suspended in a refrigeration chamber that chills your object to a cold temperature.
A foot switch then opens up a second chamber, into which you dip the chilled model. This second chamber contains a heavier-than-air vapor from a rather expensive liquid chemical called Vertrel. The hot vapor instantly condenses equally on all nooks and crannies of the chilled model – and then slightly softens the ABS. Chilling is perhaps the longest portion of the process.
A dip of only 30 seconds is necessary to get preliminary results. Repeated chilling and dipping gradually improves the process. Here you can see fantastic results of a scanned figurine printed at 0.25mm resolution. It’s very smooth – and even glossy!
A closeup view of the figurine before and after shows the capability. This was obtained with only two dips. We expect prints of 0.1mm would come out almost perfectly smooth and glossy.
There are limits. This figurine was printed at a huge 0.5mm resolution and despite repeated dips into the Vertrel vapor, it just would not smooth out properly. Rule of thumb: 0.25mm or less to get good results.
While the FinishingTouch produces amazing results, there is one slight problem. It’s expensive. Very expensive. Over USD$30K expensive.
If you happen to have access to one, you’re very lucky. If not, you’re probably going back to acetone.
Idea: Could the acetone dipping process be improved by pre-chilling the object? We think so.
Kerry Stevenson, aka "General Fabb" has written over 8,000 stories on 3D printing at Fabbaloo since he launched the venture in 2007, with an intention to promote and grow the incredible technology of 3D printing across the world. So far, it seems to be working!
Looking for more stories on 3D Printing? Try our Archive where thousands of our previous posts are easily found.
We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.
Welcome to Fabbaloo, one of the world’s oldest online news sources for 3D printing news. We’ve been in operation since 2007, where we first started examining the state of 3D printers. These devices are now relatively common among some circles in today’s world, but years ago it was extremely rare to see a 3D printer or even a 3D printed object.
At that time it was challenging to find any 3D printing news, so we decided to make our own site that covered 3D printer news, and even associated technologies like 3D scanning and 3D modeling. Today it is common to find 3D printers in schools, workshops and makerspaces, and you probably have been using 3D printed objects without even knowing they were 3D printed.
Today’s industry has finally taken up the challenge by installing thousands of industrial 3D printers, each producing previously impossible 3D printed parts that make today’s society far more efficient. The aerospace industry in particular has been producing many 3D printed parts, some even for flight critical purposes.
If you want to learn about 3D printers, then there’s no better place than Fabbaloo’s 3D printer news to see the latest happenings.
Strictly Necessary Cookies
Strictly Necessary Cookie should be enabled at all times so that we can save your preferences for cookie settings.
If you disable this cookie, we will not be able to save your preferences. This means that every time you visit this website you will need to enable or disable cookies again.