Stratasys Smoothes it Out

By on December 18th, 2008 in blog

Tags: ,

 
One of the shocks encountered by those first seeing a 3D printed object is that they aren’t always smooth. We’re all used to seeing and feeling totally smooth/polished plastic objects, and when we handle or look closely at a 3D printout we instantly recognize roughness. This often puts the objects in a bad light, as if the manufacturing process were somehow broken. “Obviously this technology isn’t ready yet.” Sure.

But now Stratasys is taking direct aim at this issue by releasing the “Smoothing Station”. It’s a separate unit from the actual 3D printer, and is used after the parts are produced.

According to their press release:

The Smoothing Station consists of two interior chambers that together are approximately the size of a small chest freezer. The first chamber treats the thermoplastic part  for 15 to 30 seconds to smooth the outer surface of the part. The part is then moved to the second chamber, which holds the part while it cures from the initial process. After just 30 ā€“ 45 minutes, parts can be touched, with parts fully cured in 12 ā€“18 hours or less.

There is virtually no preparation required with the smoothing process. Users simply remove support material and place the cleaned and dried part into the chamber. Parts typically are finished in one to three exposures, depending on the smoothness desired.

We believe this to be a significant development, as it quite literally addresses a concern that is in the hands and eyes of every user of 3D technology. Perhaps eventually this capability will be built into every 3D printer?

Via Stratasys

By Kerry Stevenson

Kerry Stevenson, aka "General Fabb" has written over 8,000 stories on 3D printing at Fabbaloo since he launched the venture in 2007, with an intention to promote and grow the incredible technology of 3D printing across the world. So far, it seems to be working!

Leave a comment