Creality to Release a CFS2?

By on November 16th, 2026 in Hardware, news

Tags: , , , , , ,

Is this the Creality CFS2? [Source: FCC]

It appears that Creality is about to release a new filament box, the CFS2?

In an FCC filing, Creality posted the user manual for the new device, called the “CFS2 Filament Management System.”

The user manual basically shows how to set up the CFS2 but does not explain the features. However, we can go through the documentation and make some guesses about this device.

First, the most obvious feature is that there are two chambers, each holding two spools of filament. As each apparently requires desiccant, that means both can act as filament dryers. Why two chambers? It means you can set two different drying temperatures, one for each chamber.

That would be important if high-temperature drying was a feature, and that seems likely. One chamber could be a high temperature that might melt PLA, but the other could be a lower temperature to handle lesser materials.

CFS2 (?) chaining example [Source: FCC]

On this diagram, you can see that it is possible to daisy-chain a series of units together to enable many more colors and materials in a single print job.

CFS2 (?) operations panel [Source: FCC]

The display screen shows the usual information, like temperature, humidity, set points, etc. However, note that the temperature reading can only be two digits. That suggests that the maximum drying temperature is less than 100C. Probably it is 85C, suitable for some high-temperature materials.

There are presets for typical materials, so that should make things easier for operators.

We don’t know when the CFS2 might be released, but it’s evidently soon, as FCC filings typically precede a product announcement.

My suspicion is that the CFS2 would be partnered with the company’s new KliTek-based K3 system, which as it stands mounts spools on the outside of the box. The CFS2 would make things a lot neater and allow for more colors.

By Kerry Stevenson

Kerry Stevenson, aka "General Fabb" has written over 8,000 stories on 3D printing at Fabbaloo since he launched the venture in 2007, with an intention to promote and grow the incredible technology of 3D printing across the world. So far, it seems to be working!