Design of the Week: 3D Printed Engine

By on November 16th, 2026 in Design, news

Tags: , , , ,

(Mostly) 3D printed engine [Source: YouTube]

This week’s selection is the 3D Printed Engine by YouTuber Alexander’s Laboratory.

Printing a whole gasoline engine? Yes, that’s (almost) what has happened here.

But wouldn’t some of the plastic parts be exposed to heat and melt? Yes, that would happen, but here Alexander has conveniently used some metal parts for the thermally critical areas of the engine. In addition, it seems that the crankshaft is also metal.

However, the majority of the rest of the engine is 3D printed.

I was getting quite concerned while watching the video, as the engine, when running, would emit a huge amount of toxic exhaust. As the video progressed, the amount of visible exhaust seems to accumulate, making for a very unsafe workplace. Was any proper ventilation used?

But does the engine actually work? Well, sort of. In the video you’ll see a series of failures of one kind or another. One problem was that the gears powering the water pump basically wore away due to the heat of friction — in only a few minutes of operation.

Shaking also broke a capacitor, and there were a number of other failures. In the end, I don’t think the engine actually ran properly for any substantial length of time.

Nevertheless, this is quite an impressive project, something I could not imagine doing with a 3D printer.

But, let’s be real here: you should not 3D print an engine.

Via YouTube

By Kerry Stevenson

Kerry Stevenson, aka "General Fabb" has written over 8,000 stories on 3D printing at Fabbaloo since he launched the venture in 2007, with an intention to promote and grow the incredible technology of 3D printing across the world. So far, it seems to be working!